Ductility of cross-laminated timber buildings, influence of low-cycle fatigue strength and development of an innovative connection

This thesis is mainly focused on the seismic behaviour of cross laminated timber (CLT) buildings. The document can be subdivided into three main sections closely related to each other. In the first part, after a short introduction on the state of the art on timber buildings regarding the constructive and legislative issues, the behaviour of CLT buildings is presented. The research is focused on the study on single shear-walls, on the multi-storey single-walls and on the behaviour of the whole buildings. The analyses are performed in order to assess the ductility level achievable by a CLT building as a result of different choices for the ductility of the connections at the foundation level. In order to estimate the ductility level, a large number of non-linear analyses were performed. This was possible thanks to a Matlab code, specifically developed, which allowed to reduce the computational burden. The results are used to evaluate a reliable set of behaviour factors to be applied in the seismic design of CLT buildings. In the second part of thesis, the low-cyclic fatigue strengths for different typologies of dissipative timber connections are presented. The low-cyclic fatigue strength represents a key-parameter in the assessment of the seismic behaviour of timber connections. In fact, high values of ductility associated with low values of strength degradation ensure a remarkable and reliable energy dissipation without a significant loss of strength. Despite the current version of chapter 8 of Eurocode 8 requires specific values of seismic demand for timber connections in terms of low-cyclic fatigue strength, no specific provision is reported to this regard in the European Standard for the cycling testing of timber connections and assemblage in seismic design (EN 12512). In This Standard the ductility capacity and the impairment of strength are calculated as separate mechanical parameters. For this reason, a proposal of revision of European Standard EN12512 is presented and discussed. The third and last part of the thesis describes an innovative connection for CLT buildings. This innovative connection was originally developed in order to absorb both traction and shear actions. Furthermore, a good performance has been obtained in terms of low-cyclic fatigue strength and ductility, with the aim of conceiving a connection able of satisfy the requirements of the current seismic European Standard. The design of this new connection was an iterative process, starting from some simplified numerical models. After some improvements, it was possible to obtain the expected performance levels. The strength and rigidity of the designed connection were initially obtained through numerical analysis, and then compared with the results of physical tests carried out in the Materials and Structures Testing Laboratory (MSTL), that is a part of the Department of Civil, Environmental and Mechanical Engineering (DICAM) of the University of Trento.